Airsoft Hi-Capa Carbine Kit

I love this one!

This is a 3d printable multi part model that comes together to form a full length carbine for your pistol. It is great for those airsofters that don't have access to larger print beds so can be printed in an area less than 14cmx14cmx14cm.

This is great as it really enhances the look of a pistol, making it look more fearful especially as a primary. It really increases the shooting accuracy and really stands out from the crowd. When i first shot this I was blown away, its amazing basically a GBBR.

This simply slides over the bottom rail and is then locked into place with either a bolt through the pistol or one of the 2 included locking devices to the frame.

The individual pieces all have locking mechanisms to allow you to slide the included bolt design through and glue them in place. Easy peasy! BTW the slide can be racked by hand or with the included bolt that just needs to be glued together but you can either glue the bolt to the rear sight or just take it of after you rack it and put it in your pocket.

This fits an SSP1 by novritsch as this is the pistol that I own so I cannot say for certain weather it would fit other Hi-Capas. Also this kit is in multi part so with different printers may need sanding or filling to slot them together and get a good fit and also that this kit does require self assembly preferably with glue or resin so the end result will always be unique to each build and the strength will of course vary depending on how it is put together. All I can say is I got it to work smoothly and I hope you can get as much enjoyment from it as I can.

For airsoft use only!
If you have any questions feel free to message me.

I printed this on my flashforge finder in PLA at 195 Celsius and it went great but different printers, software and filaments will require different settings and may need scaling up or down on different parts to acquire the desired result.
Just in case you are wondering I used:
195 degrees
3 bottom Layers
3 top layers
3 perimiter layers
A fair few auto generated supports
A bit of superglue
0.18mm layer height
sand paper
But most importantly Patience