HSW Filament Shelf
Remixed by
Copyright Claim
HSW Filament Shelf
Remixed by
Boost
22
53
8
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
2.7 h
1 plate
Boost
22
53
8
1
51
32
Released
Description
This is a remixed tape holder for the HSW (Honeycomb Storage Wall).
I used ½ inch (12.7 millimeter) PVC for the rails, which was readily available from the local hardware store.
Printed at .2 mm per layer 10% gyroid infill).
For the best support of the shelf, print with the orientation provided (laying on its side)
Comment & Rating (8)
All
Mine Printed where they fit in the inserts but do not hold well at all. the slightest amount of weight and they come out of the HSW Storage Inserts. Any Ideas?
The designer has replied
0
Reply
These inserts might help you if the standard ones from makerworld are too loose
https://www.printables.com/model/772671-smaller-insert-hole-for-tighter-fit
0
Reply
The ones in the picture and currently holding up my shelf are:
https://makerworld.com/en/models/133125#profileId-144364
0
Reply
Thank you for providing the model. It is greatly appreciated.
The designer has replied
1
Reply
Always happy to help in the community. This model happened to solve a particular problem for me, and hopefully it will for others as well.
0
Reply
How do the mounts hold all of that weight?
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
Related Models
© 2024 MakerWorld