Summary

Presenting the Floppy Sperm Whale!

This is a print-in-place, articulated sperm whale. Place it on a curved surface or with its tail hanging off a mantle to display it in all its articulated glory! Fins and tail are also articulated.

Model is about 190mm long (7.5 inches), 25mm tall, and 60mm wide including fins and tail.

I have tested it scaled down to 75% (5.5inches long), and the articulated joints worked just fine. 50% might be too tight for the tolerances. Scaling the model up in size shouldn't cause any problems.

No rafts or supports. Prints in place.

Print Settings

Printer Brand:

ELEGOO

                                            Printer:                      
ELEGOO NEPTUNE 4

Rafts:

                                            Supports:                      
No

Resolution:

0.2

                                            Infill:                      
10%

Filament:

PolyMaker PLA

Comment & Rating (6)

@user_3460902678

Hello, I really like your sperm whale. However, sperm whales are a little different from other whales in that their blowholes are actually at the front of their head, and a little off to the left. Would it be possible for you to move the model's blowhole forward?