Tesla wireless charging holder for AirPods Pro
Copyright Claim
Tesla wireless charging holder for AirPods Pro
Boost
10
37
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Boost
10
37
7
0
50
42
Released
Description
I struggled to charge my AirPods in the car when I left my cable at home, so I made this holder to keep them at the optimal height on the Tesla wireless charging pads and because I was not too fond of the look of any similar solutions. Although this solution may take longer and use more filament, the aesthetics make it worth it.
Easy to print. Any layer height is acceptable.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
very good, No issues
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great! If you use silicon case on your airpods you should print it a lil wider. I would say 4mm wider
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
this is my favorite print for this solution
1
Reply
doesn’t charge on my Tesla model y. it’s about 2cm shorter.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld