(UPDATED) Helldivers 2 LIBERATOR
Copyright Claim
(UPDATED) Helldivers 2 LIBERATOR
Boost
68
97
11
Print Profile(1)
2 Plates, 3 colors, 15% infill
Designer
18.1 h
2 plates
Boost
68
97
11
0
193
22
Released
Description
This model is an UPDATED version of my other model of the helldivers 2 liberator. There are two plates one has the gun split in half with holes for 6mmx2mm magnets. You can also glue the two parts together. The other plate has the full 3d gun. The benefit of printing the plates with the two halves is the print will be better because it uses very little supports.
Print time for the two halves: 3hr (with color) filament: 60g
Print time for full 3d model: 15hr(with color)filament: 250g
Thanks for looking at the model give it a rate if you like it!
FOR DEMOCRACY!!!
Comment & Rating (11)
All
Print Profile
2 Plates, 3 colors, 15% infill
Scaled it up as much as I could and it came out pretty good
0
Reply
Print Profile
2 Plates, 3 colors, 15% infill
Really cool
0
Reply
Would you mind if I sold the finished and printed version on Etsy? If not no worries.
The designer has replied
0
Reply
Would you consider compensating me for every print sold? I was planning on putting on Etsy myself.
1
Reply
Replying to @Better_Printer
Sure, I’ll let you know how much I decide to sell it for and you can tell me how much you would like per gun.
0
Reply
how big is it?
The designer has replied
0
Reply
It is about 7in length by 3.5in height and 0.5in width, someone printed a life size version and they scaled it up to about 400%
0
Reply
Hello, what glue do you recommend for conect the parts using pla plastic?
0
Reply
CA glue (superglue) worked very well for me
0
Reply
Thanks a lot, will be my first cosplay prop by 3d printing 👍🏻
0
Reply
I used hot glue to connect the magnets but super glue would be probably work just as well if not better if you are gluing the two halves together.
0
Reply
No more
License
This work is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld