This is a replica model of the SG 225 Breaker shotgun from Helldivers 2. There is a full 3d model or a cut in half model that can be glued together or can use 6mmx2mm magnets to connect them but I had a little trouble fitting the magnets into some of the holes so I would glue the pieces. The benefit of printing the two halves is they will have better print quality because there are very little supports, also the amount of filament and print time is way down because there is less supports.
2 halves print time: 3hr 50 min Amount of filament used 70g
3d model print time: 12hr 30min Amount of filament: 175g
Thanks for looking at this model rate the profile if you like it!
FOR DEMOCRACY!!!