Door Stop with Catch (TPU)
Copyright Claim
Door Stop with Catch (TPU)
Boost
5
5
5
Print Profile(2)
0.28mm layer, 5 walls, 15% infill
Designer
3.6 h
2 plates
0.2mm layer, 4 walls, 15% infill
Designer
3.6 h
2 plates
Boost
5
5
5
1
22
10
Released
Description
Here is my favorite door stop. Must be printed in tpu or other flexible filament. Easy to print. I like the design because the screws are hidden and it looks great.
If you want to use it to just protect your wall, print it without the door catch and with the longer bumper (Plate 2).
If you want to use it as a door catch print it with the short bumper and the catch (Plate 1).
Screw the bumper holder to the wall and then insert the bumper into the holder. It is a tight fit but it can be tapped in using a hammer.
See my other design here: https://makerworld.com/en/models/109255#profileId-121864
Comment & Rating (5)
All
Print Profile
0.28mm layer, 5 walls, 15% infill
perfect
The designer has replied
0
Reply
Looks great. You just need to push the two pieces together on the right until they lock in place. Tight fit.
0
Reply
Replying to @Bertowen
I know I just didn't want to deal with removing it again since I hadn't screwed it on yet.
0
Reply
Print Profile
0.28mm layer, 5 walls, 15% infill
0
Reply
Boosted
Print Profile
0.28mm layer, 5 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld