This is a holder/organizer for the Paul Mitchell protools hair straightener. Mostly created this so that my SO would have somewhere to quickly store the hair straightener after use while still hot. I started by printing test pieces in PLA and was going to use PA for the final print, however i found that the PLA held up very well barely getting warm. Definitely test it before you decide on the final material yourself.

This will require the following hardware to assemble:

• 3x M3 heat press inserts
• 3x 12mm M3 screws

The heat press insert are inserted into the three holes on the main body, and the cable wrap is attached with the screws. Ensure that your screws don't poke through into the body before inserting your straightener.