Hotend fan duct P1P/P1S
Copyright Claim
Hotend fan duct P1P/P1S
Boost
196
376
89
Print Profile(5)
PETG 0.2mm, 2 walls
Designer
19 min
1 plate
ABS 0.2mm layer, 2 walls
Designer
15 min
1 plate
0.2mm ASA
16 min
1 plate
0.2mm PETG
19 min
1 plate
Click to see more
Boost
196
376
89
8
521
267
Released
Description
Due to hotend design there is problem, that hotend fan is taking air to cool down from bad places where is hot air, like bellow from around heatblok and heatbed and that can lead to melt filament too soon before heatblok and cause clog. So to prevent this heat creep I designed a little fan duct to prevent that. Its made to take air directly from the side of hotend housing. Its made simply to just screw directly to part cooling fan, than you can assemble front hotend housing as normal. Hope it will help you.
Print from PETG or ABS for better heat resistance.
There is also model for X1C/X1 in my published models: https://makerworld.com/de/models/98684#profileId-105217
Comment & Rating (89)
All
Print Profile
PETG 0.2mm, 2 walls
print profile is file but model seem a little tight. I have to leave the screw a little lose so it could move around a bit, otherwise the top of the housing wouldn't snap back in to place correctly.
looking forward to seeing if it helps with creep.
(Edited)
The designer has replied
0
Reply
If you screw it there that way as on your photo its wrong. Look at my photo how it should be screwed in tbere, that cutouts should be pointing outwards from front housing.
0
Reply
hi
thanks for letting me know, I had worked it out but forgot to update the photo.
did find the Allen key fits through the screw hole, so the pass through hole could be reduced
0
Reply
Replying to @PCHuDSoN
Also did an 8 hour PLA print with the lid on and door closed and didn't have a single issue. would have been concerned about that before.
however the ambient temp has dropped which can give me warping issues. summer will be the time to see if it has improved hotend cooling.
0
Reply
Boosted
Compatible with Panda Jet Cooling Fan Duct + Hotend Panda Revo ❄️👍
2
Reply
Print Profile
PETG 0.2mm, 2 walls
worked great
1
Reply
Print Profile
PETG 0.2mm, 2 walls
Snazzy!
(Edited)
1
Reply
perfect fit!
1
Reply
Print Profile
PETG 0.2mm, 2 walls
very nice.
0
Reply
Print Profile
0.2mm PETG
Fits great and it should improve the movement of heat from the hotend. I printed it in black and silver petg.
0
Reply
Print Profile
PETG 0.2mm, 2 walls
Printed perfectly ith a little supportl
0
Reply
Print Profile
ABS 0.2mm layer, 2 walls
(Edited)
2
Reply
What kind of screws are used?
The designer has replied
1
Reply
Use original from part cooling fan as you can see on photo.
1
Reply
Replying to @Maoirae
Is the hole on the side panel small enough to provide sufficient airflow for cooling?
0
Reply
Replying to @user_3257635948
They are there to let enough air in. That fan is really small and dont take that much air.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (2)
Related Models
© 2024 MakerWorld