I was searching for an enclosure to house my ESP8266 NodeMCU CH340 ESP-12E Development Board, which I will use for a WLED project. I did not find anything suitable or to my liking. I wasted time looking at different enclosures only to find they were not the right dimensions so I decided it would be quicker to design my own.
Enclosure features:
- No screws required, snap-fit lid with a cutout to easily pry open lid
- Cutouts for micro USB, Dupont or similar connector, 8266 Flash and Reset button access
- PCB standoff blocks and pins with no requirement to screw down
- Small form factor 65(L)x38(W)x16.35(H) mm
- PCB hole spacing at 25mm x 52mm
- I used supports for cleaner cable cutouts but they aren't critical
- Easy and quick to print
- Dimensions available in pictures to see if this enclosure is suitable fo you