USB Extension Junction Box
Copyright Claim
USB Extension Junction Box
Boost
29
54
12
Print Profile(2)
Tight fit (0.2mm layer, 2 walls, 15% infill)
Designer
28 min
1 plate
Looser fit (0.2mm layer, 2 walls, 15% infill)
Designer
28 min
1 plate
Boost
29
54
12
0
52
43
Released
Description
I installed a ESP32 outside to control my WLED lights and needed an USB extension to deliver power. Since it was outside, I wanted to put it in a box to protect it from the elements. The one side fits snug, the other side I put some tape around the cable to size it appropriately.
Comment & Rating (12)
All
Print Profile
Tight fit (0.2mm layer, 2 walls, 15% infill)
Thanks for your print. It is very useful and prints so easily...
1
Reply
these were too tight to put together. i am going to try printing one of them 1% smaller. PLA.
The designer has replied
0
Reply
How did it work out for you? Mine snapped together but I can see how it might be a tight fit.
0
Reply
Replying to @TimGilbert
I decided to go a different route and not print it yet. I still might to have functional boxes vs trashing them.
1
Reply
Print Profile
Tight fit (0.2mm layer, 2 walls, 15% infill)
nice
1
Reply
there is only 1 raw file? or suppose to be 2 raw files?
(Edited)The designer has replied
0
Reply
There is one file with top and bottom side by side on the plate.
0
Reply
Print Profile
Tight fit (0.2mm layer, 2 walls, 15% infill)
Super funktionierte auf Anhieb. Passgenau
0
Reply
Print Profile
Looser fit (0.2mm layer, 2 walls, 15% infill)
0
Reply
Print Profile
Looser fit (0.2mm layer, 2 walls, 15% infill)
Other Issues
0
Reply
Print Profile
Tight fit (0.2mm layer, 2 walls, 15% infill)
0
Reply
Print Profile
Looser fit (0.2mm layer, 2 walls, 15% infill)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld