Merry Christmas Round Lantern
Boost
127
202
30
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.1 h
4 plates
Boost
127
202
30
0
257
584
Released
Description
Warning!! This takes patience to put together.
Round Christmas Lantern with 3 thin layers that fit into a base. The layers have tabs on the bottom that fit into the slits on the base. The front layer “Merry Christmas” is printed in two parts, you will need to put those two layers together to make one.
The layers are printed very thin at 0.2mm. Be careful when taking them off the heat bed. Slide the tabs on the end into the slits on the opposite end.
You can size up or down. For best results size up.
3 Layers to print and 1 base.
A tea light will sit in the middle.
You need patience when putting this together.
Comment & Rating (30)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Thanks! Nice print.
The designer has replied
0
Reply
Looks Good!
0
Reply
Thanks. Nice print :)
The designer has replied
0
Reply
Glad you like it!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed nicely. I printed them using different plates, to see which one made it the easiest to get the thin prints off. I settled on the textured PEI plate. Very cute decoration!
The designer has replied
0
Reply
Glad you like it, looks great!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
didnt come out great x/
The designer has replied
0
Reply
I would try washing your plate, it looks like you had trouble with your prime line sticking on the bottom left of the picture. Usually a good sign of a plate that needs washed with soap and hot water.
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
muy rapido y facil de imprimir. un diseño muy chulo, la sombra se ve con claridad y la verdad es que merece la pena, la decoracion navideña no me suele gustar por lo recargado que resulta y esto queda muy elegante. Enhorabuena al diseñador y gracias por compartirlo con la comunidad
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
turning on first layer cooling helped make it smoother great model
1
Reply
This is the solution! That I didn't think of it. :-) Thanks!
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
This profile was a perfection itself. Can't say something else!
The designer has replied
0
Reply
Glad you liked it! Thanks!
0
Reply
perfect for the holidays
The designer has replied
0
Reply
Hope it turns out well for you!
0
Reply
Prints very nice, but not enough bang for the buck. Too difficult to assemble cleanly; too many gaps.
Thanks for the obvious hard work!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
no encajan bien las piezas
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld