I created a set of Super Mario characters in watercolor for my son's room.
One of these characters is Yoshi. It is created in Hueforge.
If you use more than one of my characters, use the same filament for grey, black and white so that all the pictures match each other.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Basic BambuLab Green Transmission Distance: 8
PLA META Sunlu Grey Transmission Distance: 5
PLA Overture Matte Pale Green Transmission Distance: 3.5
PLA BambuLab Matte Ivory White Transmission Distance: 4
Swap Instructions:
Start with Charcoal
At layer #11 (0.96mm) swap to BambuLab Green
At layer #15 (1.28mm) swap to Grey
At layer #16 (1.36mm) swap to Pale Green
At layer #17 (1.44mm) swap to White for the rest.
See my other paintings