I printed the model, but with a test-tube as the main model to break it out.
You need a slicer for the model that generates a tree support. I used Bambu Studio.
Here I had to construct something on the ground so that the part of the test-tube stays in the air.
The test-tubes size is 160 x Ø 18mm
The flower is from printables - model/131746
Here is the link to the test tubes from Amazon:
https://www.amazon.de/dp/B07FMRJ3CR?ref=ppx_yo2ov_dt_b_product_details&th=1
Printer:
Babulab
Rafts:
No
Supports:
Yes
Resolution:
0.200
Infill:
10%
Filament: Bambulab PLA Metal Green
Notes:
You need tree support!!!