TILT PHONE STAND
Copyright Claim
TILT PHONE STAND
Boost
910
1539
384
Print Profile(8)
0.2mm layer, 2 walls, 15% infill
Designer
3.2 h
1 plate
0.2mm layer, 2 walls, 12% infill,spiral filling
3.5 h
1 plate
0.2mm layer, 2 walls, 15% infill
3.1 h
1 plate
0.2mm layer, 2 walls, 15% infill
4.1 h
1 plate
Click to see more
Boost
910
1539
384
18
5.1 k
3.4 k
Released
Description
NEW IMPROVED VERSION TILT PHONE STAND V3.0
The stand allowing you to comfortably and securely hold your mobile phone at the optimal viewing angle.
- Designed for printing completely without supported!
- You will need glue (Superglue for plastics). It is necessary to connect the parts (02_Gear_Stand_Left + 03_Gear_Stand_Right) together.
- Its possible that the gap between the base and the tilt gear will be too large. This will cause a slip. To prevent slipping, I recommend sticking the electrical tape on the guide (Base). Or you can also add a layer of glue on the contact surface and let glue dry.
- Otherwise, if the connection is too rigid, it is necessary to grind the contact surface.
Comment & Rating (384)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Waiting for a version print in place.
The designer has replied
0
Reply
I already have such a version :) https://makerworld.com/en/models/415150#profileId-317228
0
Reply
Perfect, Love it Tnx
1
Reply
perfect print but i dont get the meaning of left hand side gear. it falls off
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
funguje parádně. konečně mám u barvení kam si postavit telefon
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very nice, I had to glue 1/2’s together, I think because I used a .8mm nozzle.
1
Reply
Print Profile
0.2mm layer, 2 walls, 12% infill,spiral filling
Works very well good sir
1
Reply
wirklich tolles Teil nur leider kippt der Ständer leider immer nach hinten um wenn ich das Handy hochkant hinstelle
1
Reply
eine tolle Datei. das einzelne kleine Rad habe ich angeklebt da es sonst immer abgeht. es klappt sehr gut und sieht auch klasse aus auf dem Tisch.
1
Reply
It needs to glue but i like it 😊
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sehr gut
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Related Models
© 2024 MakerWorld