Very detailed and looks good. Didn’t have multiple greens so used a tricolor green, red, blue filament for a couple of the greens and it looks pretty good. Not sure if it’s the tree or the picture of the grinch but they aren’t quite perfectly matched when glued together but very close.
Thank you for the feedback....printed this 3 times...one time i had the same and they didn't match...not sure what changed other than the PLA shrinking a little bit on the tree :)
Printed in colours i had, i did black, then dark grey, then dark green and dark green again, then lime green and white. It's my first hueforge, turned out Amazing. Thanks OP
GrinchTree Model - 0.2mm layer, 2 walls, 5% infill
Wife loves it! Overall GREAT design!! The grinch and the tree do not match up perfectly, it's slightly off but not enough to bother me. If i did it again only thing i'd change would be to go with white at layer #30 instead, but thats just personal preference.
I used Alpine Green Sparkle for the tree.
For the Grinch I used:
- Black
- At layer #7 swap to Alpine Green Sparkle(Bambu)
- At layer #10 swap to Green(Bambu)
- At layer #21 swap to Bambu Green(Bambu)
- At layer #26 swap to Grass Green(Bambu)
- At layer #28 swap to White(Ender)