This is a replacement switch for the pictured hand warmer from "ihatethecold.com". The original fell off and got lost. This one will need to be attached with a small amount of glue. Be careful to only use a small amount and only where you need it. I used a "gel" type super glue. You could also probably use a small amount of two part epoxy.
Printer Brand:
Anycubic
Printer:
All-metal Mega
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.1
Infill:
Doesn't Matter
Filament:
CC3D PETG Black
Notes:
I recommend printing this in a heat resistant material.... because it's a hand warmer. I used PETG. I'm sure ABS would also work.
If this design was useful to you, please post a make!