A Wyze Pan Cam V3 camera mount that fits on the 20 mm extrusion used for the Ender 5 Plus. You will need the following:

1. Three M5x8mm screws
2. Two M5 T-Nuts
3. Wyze Pan Cam V3
4. The mounting screw that comes with the camera.
5. M5 threaded Brass insert for the base. (or you can cut threads)

Instructions:

1. Mount the vertical base using 2 M5 screws and two M5 T-Nuts to the printer frame.
2. Attach the camera base disc to the vertical base using the M5 brass threaded insert
3. Mount the camera to the base disc using the including mounting screw that came with the camera. You might need to fiddle a bit to get the screw in place. Easier to just push the screw up through the disc base and then set the camera on top to line it up.
4. Once mounted, run the power cable down the track on the back of the vertical base to keep it out of the way.

The camera is not particularly heavy, so 25% infill on PLA worked fine.