V-Spooler Drill Adapter
Copyright Claim
V-Spooler Drill Adapter
Boost
33
61
36
Print Profile(1)
0.16mm layer, 99 walls, 0% infill
Designer
25 min
1 plate
Boost
33
61
36
0
299
240
Released
Description
The V-Spooler V-Spooler by Fryby Additive - MakerWorld is a new re-spooler for filament that has a number of great design ideas, including use of vertical versus horizontal space. The designer created a replacement drive axle to use a drill adapter, but I wanted something I could use or not use, and adapt to the motor system I have on my current (about to be retired) respooler.
Comment & Rating (36)
All
Print Profile
0.16mm layer, 99 walls, 0% infill
qualità di stampa ok, ma poca resistenza del pezzo 😔
The designer has replied
0
Reply
Must have been a lot of torque, or perhaps not keeping the drill straight? I've been using one for months with no issue. What material did you use to print it?
0
Reply
Replying to @JeffSmith
I used pla matte bambulab
0
Reply
Replying to @JeffSmith
there is a gap in the design
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
Nice ad on the th V-spooler to use the drill.
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
it worked as I needed it to.
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
Perfect
(Edited)
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
a much needed addition to the V spooler. Although I would switch the outside circle to an hex to make it easier to print without defects.
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
Works fine
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
Fits.
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
printed fine - brass inserts...
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
functions as advertised
0
Reply
Print Profile
0.16mm layer, 99 walls, 0% infill
Macht genau das was es soll :-)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld