Flexible French Bulldog - DOG
Remixed by
Copyright Claim
Flexible French Bulldog - DOG
Remixed by
Boost
40
48
23
Print Profile(2)
Single color - 0.2mm layer, 2 walls, 12% infill
Designer
58 min
1 plate
Painted eyes - 0.2mm layer, 2 walls, 12% infill
Designer
1.7 h
1 plate
Boost
40
48
23
0
79
110
Released
Description
Flexible French Bulldog :)
Thanks to MrHanjak for this model :)
Profiles for multicolor (painted eyes) or single color are available.
Comment & Rating (23)
All
Print Profile
Single color - 0.2mm layer, 2 walls, 12% infill
it’s so cute
0
Reply
Print Profile
Single color - 0.2mm layer, 2 walls, 12% infill
Very cool, all of my friends loved it!
0
Reply
Print Profile
Single color - 0.2mm layer, 2 walls, 12% infill
Printed an entire army of these dogs. So cute- so solid. Great articulation and no problem with the connections. My favorite are printed with a two color silk PLA filament.
0
Reply
Print Profile
Single color - 0.2mm layer, 2 walls, 12% infill
So cute! I shrunk them down 50% to make them croc charms. 😁
0
Reply
Print Profile
Single color - 0.2mm layer, 2 walls, 12% infill
(Edited)
0
Reply
Print Profile
Painted eyes - 0.2mm layer, 2 walls, 12% infill
Sehr schöner Druck.
0
Reply
Print Profile
Single color - 0.2mm layer, 2 walls, 12% infill
Klasse!
0
Reply
Print Profile
Single color - 0.2mm layer, 2 walls, 12% infill
Support Issue:the supports that printed were almost impossible to untangle from hinge points. not sure if it was user error but possible.
The designer has replied
0
Reply
hi,
there are no supports in this profile and they are not required at all
0
Reply
Weird that it printed with supports when I didn’t select any. I’ll give it another go and shoot you a message if it does it again.
0
Reply
Print Profile
Painted eyes - 0.2mm layer, 2 walls, 12% infill
Super cute and wiggly
0
Reply
Print Profile
Single color - 0.2mm layer, 2 walls, 12% infill
printed great
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld