Foldable Tablett Stand
Copyright Claim
Foldable Tablett Stand
Boost
69
114
35
Print Profile(1)
0.2mm layer Standard, no Support, 12% hex infill
Designer
1 h
1 plate
Boost
69
114
35
1
368
252
Released
Description
This is a stand for the bigger tabletts, it can hold my iPad12.9 with cover. There are 2 Versions: one with 60 degrees: this is more for watching videos etc. and one with 80 degrees, this can be used to hold the pad in portrait mode e.g. for teleconferencing (the camera is then on the top side).
Both can hold you iPad secure in portrait orientation.
I added another version for the bigger phones like the Galaxy S23 Ultra (with case).
Source is included, you can customize your stand as you need it. (needs OpenSCAD and the BDSL2 library).
Assembly: press the pin through the hinge. I use a soldering iron to secure the pin on the down side. You can also glue in the small part.
Comment & Rating (35)
All
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
works as it should
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
(Edited)
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
Quick print and ncie design
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
Printed perfectly with no issues. I used a small dap of superglue to attatch the small plastic piece.
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
nessun problema ottima stampa
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
works fine
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
love this simple iPad holder. thank you
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
super strong thank you
0
Reply
Print Profile
0.2mm layer Standard, no Support, 12% hex infill
Great print!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld