University of Georgia (UGA) Keychain
Copyright Claim
University of Georgia (UGA) Keychain
Boost
8
5
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
Boost
8
5
8
0
22
34
Released
Description
University of Georgia keychain. 3MF file is setup to print face down on the textured plate with a color swap at the half way point. I printed with red PLA for the first half, then black PLA for the second half.
Comment & Rating (8)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Turned out pretty good. printed on the X1 Carbon.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld