SUNLU pla+ and silk Bambu Lab AMS Spool Adapter Ring
Remixed by
Copyright Claim
SUNLU pla+ and silk Bambu Lab AMS Spool Adapter Ring
Remixed by
Boost
30
73
27
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.5 h
2 plates
Boost
30
73
27
1
144
341
Released
Description
Description:
- I've tested these adapters on Sunlu PLA+ and Sunlu Silk
Instructions:
- Print two plates for each a single spool.
- Wide spool ring adapter should be on the right-hand side of the Sunlu spool if you're facing the AMS as you can see on image.
- See attached photos.
Printing:
- Printed with Sunlu PLA +
Comment & Rating (27)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
works in AMS as expected !
1
Reply
Didn't work well for me, the adapters are too large. The fit the spools perfectly, but they get jammed in the AMS when the lid is closed.
The designer has replied
0
Reply
I will try to prepare smaller. Maybe they change AMS lid dimensions
0
Reply
I publish new version please try https://makerworld.com/en/models/126936#profileId-137248 has lower profile and shoud fit in new AMS.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Passt einwandfrei. TOP
(Edited)1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
direct fit like a glove! thank you
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
printed ok no problems.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
work good
(Edited)0
Reply
thank you for design and share, it's very useful !
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Fixed my "AMS retraction" issues, thanks.
(Edited)0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
![Silica Dryer Spool [SUNLU]](https://makerworld.bblmw.com/makerworld/model/US4c32959aca7672/design/2024-05-30_659fc7041da368.jpg?image_process=resize,w_400/format,webp)
© 2024 MakerWorld