Another attempt at HueForge earrings!

This design was created in Craiyon.com. It was then run through HueForge. I then shaped it in the Bambu Slicer as the original shape was square. The prompt was “Abstract Sun”, but it also kind of looks almost like an eye. Regardless, I thought it was pretty fun! I did it in sun colors, but I think it could be fun in other colors like shades of blue!

Printed pieces are attached to an ear wire using 2 jump rings to get them to hang right.

Layer changes - swatches also shown in images. If you are using a single AMS (like me) have the White be the same slot as Black and as soon as the black finishes, swap out the rolls.

Layers 1 - 9 : Black

Layers 10 - 12 : Orange [Creality Pro Orange(Pumpkin)]

Layers 13 - 15 : Red (Inland Red)

Layers 16 - 20 : Gold (Matterhackers Gold)

Layers 21 - Top : White

.08mm Extra Fine settings were used with .4 Nozzle.

Ironing was used on ALL top surfaces, but this can be a matter of preference.

Gyroid infill is used where it is necessary but 100% infill could also be good with how small and thin it is.

I use a Prime Tower, but it is small. Possibly not necessary but helps sometimes.