Bear Brick (No assembly required)
Boost
76
73
23
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
5.7 h
1 plate
Fits A1 mini (180mm)
5.6 h
1 plate
Boost
76
73
23
3
264
143
Released
Description
Wanted to print some small bearbrick for my gaming room but I found most of the files out there they are either do not look like the original design OR require assembly.
This one doesn't need assembly at all. Just need support. I have tested / printed several times myself and made modifications accordingly, the final result is good. Refer photos.
You are welcome to scale up or down to suit your preference. Happy printing!
Comment & Rating (23)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
printed on P1p with Bambu tough pla. really cute ...only his legs move though.
1
Reply
can you make this print for an A1 Mini please ??
The designer has replied
0
Reply
Unfortunately I don’t have an A1 mini so I won’t be able to make the right print setting for you. Maybe somebody else who has an A1 mini can do that for you?
0
Reply
Idk if the designer minds or not but I made a model for you that should fit the A1 mini
0
Reply
Replying to @LegendsOnlyWin
Nope, I don't mind at all. Thanks for doing that for A1 mini users! :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:leider gab es keine vermerkung das es zwei Teile waren… das stellte ich leider erst beim Drucken fest
The designer has replied
0
Reply
Sorry, I am not sure what do you mean by that. There is no two parts of the model. This is a file with one single model and supports turned on for printing.
0
Reply
Replying to @JasonM
After a small inspection of the model, I found a small gap between the torso and the hips. It doesn't look like it would be too big of a deal though.
0
Reply
Replying to @Wachael
when I printed it, it came out as one, but as I took the supports off, it was clean cut from the torso to waist. I just super glued it and it looks basically identical to it as before
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
love it
2
Reply
wish you could design 400%
1
Reply
Print Profile
Fits A1 mini (180mm)
good model but paw broke of but i guess that is my fault
0
Reply
Is this much infill realy neccessary?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
schönes Modell. Leider ist bei mir der Körper in der Hälfte auseinander gebrochen. Es ließ sich aber gut kleben.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Fits A1 mini (180mm)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld