2Color, for 125mm Disk, 0.2mm layer, 2 walls, 15% infill
8.3 h
1 plate
5.0(1)
Boost
12
47
6
0
84
46
Released
Description
5 inch sanding disc holder with grit labels. If you need to modify the labels you can copy and remix on Tinkercad. I printed this with no supports and it did pretty good, a few strands loose that I cleaned up with a shart knife. I am happy.
Worked well on first print. 5 stars. My only problem was the PETG yellow didn't adhere well on one of the 4's so had to touch up with some yellow paint. Thanks for the great print! If I would change anything, it would be to make it slightly deeper with slightly wider bins, so you could put a normal box in, without opening it. Currently, it is about 1/8" too short to do that and about the same in being to narrow in each section, but that is just personal preference.