AR-15 Rifle Mag Well Wall Mount
Copyright Claim
AR-15 Rifle Mag Well Wall Mount
Boost
24
49
6
Print Profile(1)
0.2mm layer, 6 walls, 15% infill
Designer
4.4 h
1 plate
Boost
24
49
6
0
84
79
Released
Description
AR-15 Mag Well Wall mount Rifle locks into place using the magazine lock so you can mount it in any position
- 6 walls minimum
- 15% Triangle Infill
- Print as model loads as that provides the cleanest print
- Block all screw holes as supports are not needed for those
- Tree supports
- Supports Top Interface Spacing 0.7 works best for me
- I printed in PETG but PLA ASA ABS should all be fine as well
Comment & Rating (6)
All
Nice design but what is the purpose of the honeycomb between the wall and the mag post? That's a weak point, but perhaps you'd rather it break there instead of damaging the mag well? I like the mag clip on the bottom as well!
You might want to offer two designs, one with a solid mount and the current one.
The designer has replied
0
Reply
It actually strengthens it because its all walls there instead of infill :)
0
Reply
Replying to @Jiig123
I tried to print it but no luck on my X1C with PLA-CF on a PEI build sheet.
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
it feels so good and solid
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
Printed as suggested, came out decent. Some of the holes likely require additional support to come out clean
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
0
Reply
No more
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld