Hey there! This piece is a support I designed specifically to hold a pole of filament spools inside a dehumidifier box. It's super handy for keeping everything organized and protecting your 3D printing materials. A simple yet effective solution to optimize your printing setup!
- Two lateral angles for the firmness and one in the lower part for the support.
- Added an extra support at the bottom to help support more weight.
- Round out a lot of the support because it had to withstand spools and I did not want the edges to slow down the spool
- 20mm Pole
- 6mm Screws
Print Settings
- Designed in:
- Printer brand:
- Printer:
- Rafts:
- Supports:
- Resolution:
- Infill:
- Notes:
- It depends on whether you need to support a lot or little weight. With 10% and thanks to the support added below is enough.