Day of the Dead Pumpkin Lithophane for Tealight Display
Remixed by
Copyright Claim
Day of the Dead Pumpkin Lithophane for Tealight Display
Remixed by
Boost
15
28
8
Print Profile(1)
Day of the Dead Lithophane for .4mm Nozzle
Designer
2.9 h
1 plate
Boost
15
28
8
0
30
15
Released
Description
Easy lithophane for JTP's Halloween Tealight Display Case. It's about a 3 hour print using my profile with only 16 color changes. The lithophane was created at Lithophanemaker.com. I created a circular mask as a negative volume to create a round lithophane to fit the tealight display case. I used all IIIDMax PLA with the following RGB/Hex codes:
Color | RGB | Hex |
|---|---|---|
| White | 231,231,224 | #e7e7e0 |
| Yellow | 246,196,45 | #f6c42d |
| Light Blue | 34,155,213 | #229bd5 |
| Fuchsia | 162,70,141 | #a2468d |
Even if you don't have specific CMYK filaments, it should print well using standard White, Yellow, Light Blue and Pink or Fuchsia.
This one works best with 2 tealights in the display.
Thank you - MadMax
Comment & Rating (8)
All
Print Profile
Day of the Dead Lithophane for .4mm Nozzle
Excellent!
(Edited)
The designer has replied
0
Reply
Thank you!
0
Reply
Print Profile
Day of the Dead Lithophane for .4mm Nozzle
very nice :)
The designer has replied
0
Reply
Thanks for reviewing
0
Reply
Print Profile
Day of the Dead Lithophane for .4mm Nozzle
The designer has replied
0
Reply
Thank you for reviewing.
0
Reply
Print Profile
Day of the Dead Lithophane for .4mm Nozzle
The designer has replied
0
Reply
Thanks for the rating
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld