The V-Spooler by Fryby Additive - MakerWorld is awesome. I set mine up to be used with a drill. However the initial winding on by hand, while entirely doable by direct manipulation of the spool was a little irksome so I quickly created a different handle connecter that will insert into the drill hole. The connection is deliberately not super tight since the expectation is you want to quickly insert this, do a little winding, then remove and use the drill but it should be tight enough that it doesn't fall out when you try to wind. This part replaces the equivalent piece of the non-drill handle and you use the rest of the parts from V-Spooler.