- Pen support in a shape of a big dice ( 65mm cube ).
- Optimized for minimal filament loss, print time and view quality. Only 10grams of flushed filament (21 filament changes only, for 3 colors print)
- All dice faces looks good, as all of them are printed on the bed.
- Holds Up to 6 pencils, or use it only as a decor. The 6 holes for the pencils looks exactly like the other dice dots.
- Different blood texture on each side.
- All you need is some glue.
Printing and assembly tips:
- As all the faces are printed on the bed and there are some small details with 2 colors to be printed, I fresh cleaned bed is recommended and a bed leveling. This print is a good test of proper bed setup. First layer is very important.
Please clean the print bed with dish soap and hot water and don't touch it with fingers in the parts you print the models.
Be sure you have a good bed leveling and the first layer is printed good. - Gluing is not hard, but needs some patience to glue all faces. I would suggest a CA glue that is not very liquid. A gel CA would be great. A two part glue (with activator) is perfect and faster.
Try to push the faces very clone on corners, to not leave any space between them, so it look perfect.
If you get too much glue sticking out, you can easily sand it lightly to look perfect.
The model was printed with the following filaments: