Robust Shelf Bracket
Copyright Claim
Robust Shelf Bracket
Boost
33
75
31
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
1.5 h
1 plate
Boost
33
75
31
5
195
117
Released
Description
If you find this project useful, be sure to give it a thumbs up 👍🏻 to help more people discover it.
Your Boost 🚀 will also let me know that you appreciate my work.
Thanks a lot, Walter :)
This is a robust shelf bracket designed with OnShape.
The public OnShape project allows you to remix it easily, the design is parametric with variables to configure the bracket according to your requirements.
Note: Use Gyroid, Cubic, or Adaptive Cubic infill (30% minimum), and at least 3 walls for increased robustness.
Recommended position on the printer bed:
Comment & Rating (31)
All
Print Profile
0.2mm layer, 3 walls, 30% infill
initially failed due to using some troublesome PETG that I was trying to use up now now it’s great
(Edited)
The designer has replied
1
Reply
What was the problem? I did not understand
0
Reply
Replying to @myzhar
I changed the PETg that I was using and it worked
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Printed in Petg cf came out Great
The designer has replied
1
Reply
Nice print. PETG is ideal
0
Reply
Boosted
very nicely printed in the A1 mini with CF PLA
1
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Printed off 2 sets so far will be printing more. Very strong!
The designer has replied
1
Reply
Thank you :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
The designer has replied
0
Reply
Why 4⭐️? Did you face any issue?
0
Reply
Replying to @myzhar
Screw holes could stand to be a bit further from the center support, hard to drive a screw straight with a drill. It's a good print, I just don't give out 5 stars all that often.
(Edited)1
Reply
This is a good feedback. Please always justify a vote with a comment, they're useful to improve the model 😀
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
leiwand
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Printed very well. i enlarged it and used it to hold up my filament shelf. Thanks
1
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
(Edited)
The designer has replied
1
Reply
Why only 3 stars? if you faced any problem it will be a pleasure to help solving it
0
Reply
Replying to @myzhar
must have been an honest mistake. no issues with the print. came out beautifully. thanks! def 5 stars
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
I love how well it looks Exactly what I was looking for
1
Reply
Boosted
really great, used to set up a small shelf in my room for funkopops
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld