Heatbed Cable Protector with cable chain na Bambuli A1 - v1.1 by Banny

Banny

3D Printer>3D Printer Accessories

GIF

Print Profile(2)

All

0.16mm layer, 3 walls, 20% infill

Designer

1.2 h

1 plate

4.8(8)

0.2mm layer, 2 walls, 15% infill

58 min

1 plate

Boost

104

Released

Description

Heatbed Cable Protector with cable chain na Bambuli A1 - v1.1

If yourcable is damaged, you should contact support immediately and stop using printer.

Since I didn't really like the "original" Heatbed Cable Protector, I figured I'd try making my own. I've been using it for about a week, and I can't complain about anything

After seeing the Cable chain on the P1P, I started looking and there was nothing like that on my A1 :( so I made a combination of both..
I guess you could say I was inspired by the chain on the motorcycle :D
Of course you can adjust the length as you wish. Just print more Cabel chain v1.1 - base pieces.

Use is at your own risk ..

Test print on A1 and Prusa mini

I recommend printing in the same positions as in the print profile

Comment & Rating (12)

@misterdoctor

Print Profile

0.16mm layer, 3 walls, 20% infill

everything fit well

@18761769855

设计不错，非常合理。新热床还没到，先将就将就

@even107

I also received the recall information, but I chose "2" to keep it. My experience tells me that using insulation tape is the easiest and most reliable alternative.

@heyderekp

Print Profile

0.16mm layer, 3 walls, 20% infill

Ended up expanding the link to go the entire way up to the print bed. Everything fit and snapped in well!

@Vohngar

how does this protect from damage from bending? does it only allow bend to a certain degree and stop?

The designer has replied

@Banny

This part fixes the cable in the same way as the "original" bambu's . It's prevents bending of the cable at the output of the base. And the cable chain minimizes the cable's side-to-side movement .