我儿子想在车身上看到风车，所以我制作了它。我儿子最后把它放在了自己的儿童玩具车上，我觉得也确实不错，甚至想重新设计底座来适配他的婴儿车

它更适合车辆静止或者低速行驶时使用，我使用的8x3mm磁铁最多只能支撑到50km/h就会从车身上脱落，不同厂商的磁铁性能不同，请小心使用。

我会上传未开孔的底座，以便让大家自行开孔来适配手边的磁铁，或者以其他方式固定。

如果只是打印给儿童玩，不用打印底座就是一个很好的手持风车。

需要的工具：

胶水

5颗8x3mm磁铁

My son wanted to see a windmill on the car body, so I made it.My son finally put it on his own children's toy car, I think it was really good. I even wanted to redesign the base to fit his stroller

It is more suitable for use when the vehicle is stationary or driving at low speeds. The 8x3mm magnet I use can only support up to 50km/h and will detach from the vehicle body. The performance of magnets from different manufacturers varies, please use with caution.

I will upload the unperforated base so that everyone can make their own holes to adapt to the magnet at hand, or fix it in other ways.

If it's just printing for children to play with, without the need for a printing base, it's a great handheld windmill.

Required tools:

glue

5 8x3mm magnets

这里是安装gif

Here is the installation of GIF