Cup Holder Coaster
Copyright Claim
Cup Holder Coaster
Boost
62
94
1
Print Profile(1)
0.2mm layer, 3 walls, 10% gyroid infill
Designer
43 min
1 plate
Boost
62
94
1
0
62
39
Released
Description
Parametric cup holder with a honeycomb pattern to catch condensation.
It's 72mm in diameter and fits a 2022 Hyundai Tucson and a 2011 Ford Edge, but the fusion model is included. Just adjust the diameter parameter to fit your cup holder.
Printed in ASA (Polylite) but you could do ABS or probably PTEG. I would avoid PLA if you are leaving it in your car but you do you.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 3 walls, 10% gyroid infill
It printed fine and looks good. It didn't fit my Hyundai Santa Cruz but that's my fault for not remembering what shape the cup holders were. We still use them in there, there's just extra space. Made them out of ABS so they survive the summer.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld