Geometric Low Poly - Penguin - With Stand
Boost
7
6
4
Print Profile(1)
0.2mm layer, 4 walls, 5% infill
Designer
27 min
1 plate
Boost
7
6
4
1
16
13
Released
Description
I hope you enjoy this Geometric Low Poly Penguin I made! The tolerance is very snug. Just push in firm and it should go in.
Please check out some of my other geometric low poly prints!
 |  |  |  |  |
 |  |  |  |  |
 |  |  |  |  |
Comment & Rating (4)
All
Print Profile
0.2mm layer, 4 walls, 5% infill
1 corner lifted but I think it's because I'm using waste filament
0
Reply
Print Profile
0.2mm layer, 4 walls, 5% infill
Great design It was easy to print as well.
0
Reply
Boosted
grazie per la tua condivisione
0
Reply
Print Profile
0.2mm layer, 4 walls, 5% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld