Desktop stand for Apple products
Copyright Claim
Desktop stand for Apple products
Boost
42
72
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
2 plates
Boost
42
72
8
0
108
82
Released
Description
Organiser for Apple products, I printed the holder in Metal PLA with 0.1 mm layers and the inserts in TPU with 0.2 mm layers and then glued them to the holder.
All my designs and mods on MakerWorld are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)
Comment & Rating (8)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints really well, and super sturdy/relaiable.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed well
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bed Adhesion Issue:could not get to print; possibly something to do with filament?
The designer has replied
0
Reply
some suggestions: clean the build bed with dish soap and dry with a clean towel or paper, calibrate the bed level, turn off aux fan if you have one
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld