Spiral Christmas Tree Ornament - No Supports - Easy Print 4gms only
Spiral Christmas Tree Ornament - No Supports - Easy Print 4gms only
Boost
13
18
6
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
22 min
1 plate
Boost
13
18
6
0
29
18
Released
Description
A very easy to print and cheap spiral Christmas Tree Ornament for the holidays
Only uses <4gms of filament.
Printing Instructions:
- Layer Height: 0.2mm (Important for multicolor prints)
- Material: PLA
- Infill: 100%
- Supports: No
- Rafts: No
- Brim: No
For Multicolor:
- Start with a base color (red in my case), Slice the model.
- In the preview window, at start of layer 3, change filament to Green, then slice again
- Happy Printing!!!
Assembly: Press fit all the spirals in order to achieve the spiral effect. Easy. They should snap into the holes perfectly.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 100% infill
very fun to put together. it is small just be aware of that. might need some shaping after all snapped in.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
Tricky to put the small parts into the bottomplate.
I destroid it during i tried to mount it.
The designer has replied
1
Reply
Yeah, a little tricky.
Tried a bigger thickness for the spirals, but it doesn't bend properly and break instantly.
Let me know if you have any suggestions.
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
esay to print, a bit hard to get the little knobs into the ring 😄 But overall a great design. many thanks for sharing.
The designer has replied
1
Reply
Yup. Need to have good bed adhesion. Thanks for the comment. Glad you liked my design.
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld