Viking Ship Stick Incense Burner
Remixed by
Viking Ship Stick Incense Burner
Remixed by
Boost
90
91
23
Print Profile(2)
0.4mm nozzle, 0.1mm layer, 4 walls, 15% infill, supports
Designer
10.8 h
1 plate
0.2mm layer, 2 walls, 50% infill
3.5 h
1 plate
Boost
90
91
23
4
215
117
Released
Description
Printed on Bambu Labs X1C using Hatchbox Wood Filament.
Use supports for the shields specifically and anywhere else you feel like it would be beneficial.
Mostly default print settings for Bambu Slicer. 15% infill works but I have had them break at the top end peaks if dropped onto a hard surface.
Comment & Rating (23)
All
Print Profile
0.2mm layer, 2 walls, 50% infill
got a little careless removing supports and had to glue the aft, but other than that it was great.
The designer has replied
0
Reply
I like Bambu's tree supports. They do seem to come off easier when you crush them using needle-nose pliers.
0
Reply
Print Profile
0.4mm nozzle, 0.1mm layer, 4 walls, 15% infill, supports
stark verkleinert und trotzdem toll. 😍
0
Reply
Print Profile
0.4mm nozzle, 0.1mm layer, 4 walls, 15% infill, supports
Came out very good !
0
Reply
Print Profile
0.4mm nozzle, 0.1mm layer, 4 walls, 15% infill, supports
Nice looking model.
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
0
Reply
please make one with no incense holder
0
Reply
Print Profile
0.4mm nozzle, 0.1mm layer, 4 walls, 15% infill, supports
Support Issue:many supportu not work great
0
Reply
Print Profile
0.4mm nozzle, 0.1mm layer, 4 walls, 15% infill, supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld