Megalodon Realistic
Copyright Claim
Megalodon Realistic
Boost
28
56
26
Print Profile(3)
0.2mm layer, 2 walls, 10% infill
Designer
7.2 h
2 plates
Full Sized with Keyhole Filament Pins; .2 adaptive layer height, .4 nozzle, lightning infill
6.1 h
2 plates
.4mm, Scaled Down, Filament Pegs to Assemble, 10g of filament, print by object
1.4 h
1 plate
Boost
28
56
26
4
149
149
Released
Description
Created in Fusion 360 and blender. Realistic in most ways possible. Model is cut in half to fit on a Bambu build plate. Only the front half of the Meg needs supports, ON BUILD PLATE ONLY, or you will never be able to remove them from the mouth. The mouth does not need supports in any way.
Cult3d link for uncut version:
Comment & Rating (26)
All
Boosted
It looked so cool thank you. Made a little stand for it.
The designer has replied
1
Reply
looks great! can barely see the seam line
0
Reply
Boosted
Replying to @finkens14
no i glued it really good
0
Reply
Boosted
Replying to @finkens14
no , just glued it really good.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
great print. This is the first time I’ve ever printed a cut model this one doesn’t have key holes to match up. Remember to set support to build plate only so there is no support in the mouth. I printed this one on the X1C.
The designer has replied
1
Reply
I tried adding keyholes to it, but the tolerances were sometimes too tight and it would leave a gap between the two pieces. So I figured I’d just use a quick setting glue and line it up very carefully. Works 99% of the time.
Thanks for the review!
0
Reply
Replying to @finkens14
I published a 3mf that has the keyholes added. hope it helps you guys :)
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Printed nice. thanks
The designer has replied
1
Reply
That looks great! Thanks!
(Edited)0
Reply
Boosted
Very cool model. I painted it, and it's still awesome.
1
Reply
Boosted
Print Profile
Full Sized with Keyhole Filament Pins; .2 adaptive layer height, .4 nozzle, lightning infill
Printed great.Multi cooler print.Hand painted belly.
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
I added keyholes but i scaled it down quite a bit, but it still looks good! I published the 3mf
(Edited)
1
Reply
Whenever I open the file in Bambu Studio it puts it on 2 separated plates.
What did I do wrong?
Look photo
The designer has replied
0
Reply
Yes that's correct. Its on two separate plates on purpose
0
Reply
For some reason my tail piece warped on the base - maybe too much heat - so there is a gap that needs filling, but overall the model is amazing.
Some locators would have been nice as I am not very good at lining up whilst glueing.
The designer has replied
1
Reply
add a brim or glue to help
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
came out great!!
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld