Echo Dot Night Light
Echo Dot Night Light
Published 2019-03-01T15:05:10+00:00
Echo Dot + Shark Lithograph holder. Also customizable (explained below)
You can customize your own lithograph and place on top of your echo dot. A secret command "Alexa start nightlight" will activate the night light and the light will strobe continuously until you give it another command. I went with a shark themed lithograph to contrast well with the blue-green tint of the light. It makes it look very real!
Your lithograph needs to have an internal diameter of 84 mm and outter of 88mm max. You can use http://3dp.rocks/lithophane/ or phototomesh to accomplish this.
I printed with .6 minimum thickness and 1.6 maximum. You can vary the settings based on the image to make it pop!
Every printer has its own +/- sizing. Do a small test print with your lithograph before finishing a whole one since they take a while.
Print both right side up. I did .2 layer height with white PLA for the lithograph and black pla for the base.
Date published | 01/03/2019 |
Time to do | 700 - 800 minutes |
Material Quantity | 50g |
Dimensions | 90 x 90 x 120 |
Support Free | YES |