Battlemace 40 Million Lee Mann Mk V Tank

This is a 32mm scale tank for Battlemace 40 Million. Scaled around the similarly named tank by "The company-that-shall-not-be-named", this tank comes with tons of options to allow you to build the tank of your dreams.

Inspired by the tank from Indiana Jones, it features a hull closely inspired by the Mark IV tank from WW1, with a turret inspired by the Churchill series of tanks from WW2.

The tank is modular, with various build options- including tracks with grouser spuds (the shovel-like projections on the sides of the tracks), and those without.

Loadout options are snap-fit, allowing you to create any variant of the Lee Mann tank from Battlemace 40 Million, without the need for glue. This tank also includes all variations of weapons to allow you to use this tank as a stand-in for the Sigillite Coach tank, from the same game.

The tank has been carefully cut into parts for easy printing. It features a hollow hull with a hinged snap-fit hatch on the bottom, so you can store extra loadout options inside the tank. This also allows you to access the sponson mounts, which rotate. The sponsons swivel around a ball-and-socket snap-fit joint. The hull sections are designed with drainage and hollowing built in, and all pieces of the tank are angled such that they can be imported into your slicer software already in the best angle to be supported with.

If you don't need sponsons, there is also a version of the side plates without them. The sponsons themselves are snap-fit as well, so you can easily swap the entire sponson option out as desired.

A scanner floodlamp and stalker-killer missile addon are able to be mounted to the turret, if you use them in your loadout. If you don't need them, there is a decorative gun slit cover that can be mounted over the holes for the two addons.

The hatches on the turret can be posed open or closed, and the turret is hollow, to allow you to place a commander in the hatch if you like.

The turret itself uses a rail locking system, allowing you to attach the turret without the need for glue. The turret rotates freely, and can be removed for storage or transport as needed.

The entire tank is very easy to print, and fits on even smaller print beds like the original Photon Mono series of printers.

Parts of the print have been carefully angled for the recommended print placement. Auto supports are fine, with some slight tweaks recommended.

This kit is designed for resin printers.