Low poly claws perfect for any Halloween costume, cosplay, or general claw related fun!
I learned from past 3d projects for this design, but still ended up with a lot of trial and error to fine tune the claws. However they still fit a wide variety of finger sizes thanks to the rubber band's tensioning.
For the wrist band I used 1/2 inch webbing and 1/2 inch buckles and to secure the individual claws to the band I used 2 1/2 x 1/16 inch and 1/4 lb rubber bands (I'm sure plenty of different rubber bands work just as fine).
I printed at 0.2 mm layer height, 3 walls, 10% infill, 5% support density, and with a brim. (Settings used for the gcode file)