5.8L rice barrel drying box to prevent material from tangling with temperature and hygrometer

5.8L rice barrel drying box to prevent material from tangling with temperature and hygrometer

Boost
20
64
6

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
6.8 h
3 plates
5.0(1)

0.2mm layer, 3 walls, 18% infill PETG
0.2mm layer, 3 walls, 18% infill PETG
5.9 h
2 plates

Boost
20
64
6
0
231
7
Released

Description

原创5.8L米桶料架有以下特点

1.底部可容纳20cm*9cm*2.5cm的干燥剂,可使箱内干燥程度可达2%左右;

2.预留小米温湿度计2这款温湿度计的槽位,可从前方观察;

3.使用4个608轴承来作为滚轮,低速轴承不会使料盘转动过快导致缠料;

 

The original 5.8L rice bucket rack has the following features

1. The bottom can hold 20cm*9cm*2.5cm of desiccant, which can make the dryness in the box reach about 2%;

2. Reserve a slot for the Xiaomi Thermohygrometer 2, which can be observed from the front;

3. Use four 608 bearings as rollers. The low-speed bearings will not cause the material plate to rotate too fast and cause the material to tangle;

Comment & Rating (6)

Please fill in your opinion
(0/5000)

放不进去608
0
Reply
我用 626 可以
0
Reply
用PETG打印的,打印完完全放不进608轴承。
The designer has replied
0
Reply
额,不至于啊,我看好多人打印都能完美放进去呢,我模型的公差还是放大了的
0
Reply
根本用不了
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more