Skadis Paper Towel Holder (Quick Load)
Remixed by
Copyright Claim
Skadis Paper Towel Holder (Quick Load)
Remixed by
Boost
6
7
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.6 h
1 plate
Boost
6
7
2
0
28
17
Released
Description
This model is a fully printable paper/shop towel mount with a quick load function for ease of use (and tactical towel reloads, of course). No dowel rods required! Fits the IKEA Skadis, and can be removed/adjusted as needed.
Remixed from YG_SH's Skadis version for better tolerances and for all parts to be printed on the same plate.
Provided 3MF file contains all parts to be printed at once.
NOTE: The right screw must be threaded in left since it was mirrored.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
this works absolutely amazing!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:Works well but it was a pain to put together. the parts don’t make sense and don’t line up well. I don’t want to knock it too hard since its a remix that. I had to hammer the dovetail in, and you have to slide it past flush until the part itself is flush, otherwise the paper towel roll rubs. A few extra pics of an assembled half would go a long way.
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld