Headlight Relocation Kit designed to be used with the Axial SCX24 C10, Deadbolt, Jeep, and Bronco editions. The Headlight lenses can be glued on after the original headlight stickers have been removed. The holes for the stock lights will need to be drilled out with a 3mm drill bit, this is extremely easy and removes very little material, just enough for the lights to snap fit in. The bumper light fillers can be snapped into the position of the original lights without any work to the print or the bumper.

Here are some higher quality images than what Thingiverse allows https://imgur.com/gallery/huQLgeE

Note: Bumper fillers were not installed in these images

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

Any

Infill:

Filament:Any Any, PLA is best however CLEAR FILAMENT ONLYPost-Printing=============

1. Remove stock lights from original mounts
2. Drill out the optional light holes in the grill with a 3mm bit
3. Remove the stickers from the grill
4. Install lights into the grill
5. Glue lenses into the grill
6. Remove lights
7. Snap bumper fillers into the bumper
8. Reinstall lights and show off your new lights