HueForge Darth Vader Portrait - Star Wars
Boost
31
38
13
Print Profile(2)
0.08mm layer, 2 walls, 100% infill
Designer
3.2 h
1 plate
A1 Mini 0.08mm layer, 2 walls, 100% infill
Designer
2.1 h
1 plate
Boost
31
38
13
0
72
21
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Swap Instructions:
Start with Black
At layer #14 (1.2mm) swap to Red
At layer #25 (2.08mm) swap to White for the rest.
Comment & Rating (13)
All
first attempt at printing a hue-forge image. it's not brilliant, but I'm fairly happy.
I am disappointed that the watermark shown on the artists image printed though, that was just unnecessary and ruins it.
The designer has replied
1
Reply
Ah, thank you for pointing that out! I will get a new version uploaded tomorrow. Thanks!
1
Reply
Hey again, just wanted to let you know that I've uploaded a new version of both the X1/P1 print profile and the A1 profile. The watermark has been removed.
Thank you again for pointing that out!
1
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
spaghetti
The designer has replied
0
Reply
that’s unfortunate, what filament? I’ve printed this without issue on an x1, p1 and both of my sons a1 minis. all using Bambu labs filament
0
Reply
Bambu white with some overture black and red. on a Bambu a1. I had to comepletely tear apart the printer to fix bed the finalment got in the bottom rails :(
0
Reply
Replying to @spencermoxley1
so strange, Hueforge prints are usually very consistent from printer to printer because of the layer approach. I’ll buy some of the overture black and red to try on my machines too
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
would have been 5 stars if the artists instagram id hadn't been on the front of the design meaning it prints too.
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
Great picture thank you.
0
Reply
I used Bambu White and Red but any brighter red filament should work.
(Edited)0
Reply
Print Profile
A1 Mini 0.08mm layer, 2 walls, 100% infill
Other Issues:colors not right. rough print
The designer has replied
0
Reply
What colors did you use? I've printed this several times with the colors listed and have not had any issues
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld