Dango The Water Bell

Dango The Water Bell

Boost
17
25
2

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
2 plates
4.5(2)

Boost
17
25
2
0
24
17
Released

Description

Meet Dango the water bell.

 

To use Dango simply submerge and let it fill up with water, then cover the hole at the top.

Once Dango is above the desired simply lift your thumb off the hole and a gentle shower will occur.

 

Can be used to:

  • Water pot plants
  • Shower babies
  • As a kids toy in the bath

And I'm sure many more..!

 

Please note they face details should be printed slowly or they are likely to fail

 

Enjoy c:

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
prints nice, a little lower than the eyes, it comes out a little rough (printed twice)… didn’t print eyes yet
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more