Demo video:
https://youtu.be/S0UYIXznOb0

Build video:
https://youtu.be/A49zsG_WUeo

This is a single motor 2 function remote controlled toy robot. It can move forward or spin in place for steering. I have designed similar robots in the past but this one is simpler to build. It is controlled by the transmitter and receiver from a Coke can RC car. It uses a yellow TT motor with dual shaft output. It is powered by 2 AAA batteries. The hardest part of the build is the electronics.
The main_body has a sacrificial bridge that needs to be trimmed out. The head is glued to the Main_body. The inlay parts are glued to the main body so they can be printed in different colors. The grill is glued to the main body. The grill is printed with a layer height filament change so it can be 2 colors. The parts that have to turn freely on 3mm screws will probably need to be drilled out with a 3mm or 1/8 inch drill. The 3mf files are Bambu studio project files.

Hardware needed:

Coke can RC car

The hardware required is 3MM screws of various lengths:
https://www.amazon.com/gp/product/B08LVT7Y8R/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&th=1

O rings from Harbor Freight O ring Kit:
Tires #214: ID 24.7MM, OD 31.7MM, Section 3.5MM
Floating idler tensioner #006: ID 2.8MM, OD 6.6MM, Section 1.9MM

2AAA battery box

Yellow dual shaft TT motor

2 red 5MM leds
2 resistors in the 100 - 200 Ohm range

power switch:
https://www.amazon.com/Position-Breadboard-Electronic-Miniature-SlideSwitch/dp/B09R43HCY3/ref=psdc_306596011_t1_B07RTJDW27?th=1

4 magnets 6MM X 1.5Mm