Heater Cover - Upgrade - QIDI Q1 Pro
Copyright Claim
Heater Cover - Upgrade - QIDI Q1 Pro
Boost
15
13
2
Print Profile(1)
0.16mm layer, 6 walls, 35% infill
Designer
51 min
1 plate
Boost
15
13
2
0
71
3
Released
Description
**ATTENTION** This must be printed with Nylon or PET-CF (150C+ softening or higher)
This is an extra safety measure for peace of mind if you're worried about electrical shock while the heater is on.
This replaces the 4 plastic washers, unscrew the 4 long machine screws, remove the 4 washers, and mount this in place of them.
ENJOY!
Comment & Rating (2)
All
Hi! I just wanted to ask if you annealed the PET-CF part before installing it and how it was holding up.
The designer has replied
0
Reply
You won't need to anneal it, but I received it late yesterday and have been switched over to the Ender KE printer for the last few days, I'll print one shortly and run some tests, the temp ratings far exceed the amount of heat that is put out according to my IR heat gun, and QIDI recommends this material as well, so it should be good as-is, no annealing required.
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld